Home › Blog › What the grease interceptor calculator does not decide
Industry & Practice

What the grease interceptor calculator does not decide

A GPM from a sink is not a permit from the sewer district.

InstaPreView · Published November 12, 2026 · Updated November 12, 2026
Line drawing of a grease interceptor in section, with inlet, baffles and outlet, titled “What the grease interceptor calculator does not decide”. InstaPreView by Byts & Bytes.

The grease interceptor calculator answers a sizing question from the sinks you type in. It does not answer whether the sewer utility accepts that method, whether the health department cares where the interceptor sits, or whether the plumbing code even wants an interceptor on this fixture. Those are three other authorities. A number from the tool, printed alone on the plumbing sheet, gets rejected by at least one of them.

The tool is at /calculators/grease-interceptor. You enter basin length, width, and depth, and it reports a hydromechanical rating or a gravity capacity from that volume. Use it to check the arithmetic. Do not describe its factors as a quotation of the plumbing code. The code discussion is the grease interceptor guide. Read the adopted plumbing code next to that guide. The model building code, which is not the plumbing code and not the utility ordinance, is at ICC. The utility's FOG rule is a PDF on the utility's site. It often names a different formula, a minimum size, or a requirement that the interceptor be outside. None of that is in the calculator.

What to put on the sheet so the comment is short:

  • The fixtures that drain to the interceptor, matching the equipment schedule and the foodservice plumbing guide.
  • The method: basin volume from the calculator, or the utility's method, or both if they differ. If they differ, design to the one the authority having jurisdiction for that pipe will enforce. Say which.
  • The type, hydromechanical or gravity, in words. The calculator asks you to choose. The detail has to match the choice.
  • A note that kitchen hoods and suppression are a different review. The hood guide is not an interceptor.

The mistake is an interceptor size with no fixture list, or a fixture list that includes the dishwasher the utility prohibits from discharging to the interceptor. Read the utility sheet before you connect every drain "to be safe."

Confirm the building-code edition on the jurisdictions page, and confirm the FOG rules with the utility. Then upload the plumbing plan and run a free scan. The scan will not call the sewer district. You still have to.

This is advisory. It is not a determination by the authority having jurisdiction or the sewer utility. Confirm the adopted plumbing code and the utility's rules before you change a drawing.