Home › Blog › What to verify after the equipment schedule extracts a spec sheet
Industry & Practice

What to verify after the equipment schedule extracts a spec sheet

The tool read the PDF. It did not design the kitchen.

InstaPreView · Published November 12, 2026 · Updated November 12, 2026
Line drawing of a construction drawing sheet with a title block and a revision cloud, titled “What to verify after the equipment schedule extracts a spec sheet”. InstaPreView by Byts & Bytes.

The equipment schedule builder will take a spec sheet or a product link and fill a row: manufacturer, model, volts, phase, amps, watts. Those cells are a head start. They are not a fact until someone compares them to the PDF and to the plan. The tool flags extracted fields for that reason. Clearing the flag without looking is how a 208-volt oven lands on a 480-volt panel schedule.

The builder is at /calculators/equipment-schedule. The columns it keeps are the ones reviewers already ask for: tag, description, manufacturer, model, quantity, plumbing, volts, phase, amps, watts, and connected load. The equipment schedule guide is why those columns exist. The connected load guide is the electrical side of a commercial kitchen. This post does not cite a National Electrical Code section for how to add the loads. Use the adopted electrical code for the service calculation. Use the schedule to stop the architectural plan, the mechanical plan, and the electrical plan from describing three different appliances.

Check every extracted row against three things.

The PDF. Model number, voltage, and phase are the cells that come back wrong most often, because cut sheets bury them. If the PDF and the cell disagree, the PDF wins and you edit the cell. Then you understand why it was wrong before you trust the next row.

The plan. The tag on the schedule is the tag on the floor plan. A schedule full of equipment the plan does not show is a coordination comment. See schedules that do not match the plan. In a kitchen, the tag also decides the hood. A fryer is not a Type II hood problem. The hood guide is that split. The model mechanical code, not the spec-sheet parser, is the authority. The model IBC, for the occupancy around the kitchen, is at ICC.

The drains. If the unit needs a floor sink or an indirect waste, the plumbing column has to say so, and the foodservice plumbing guide is the code side.

The mistake is exporting to Excel the moment the extraction finishes and sending that file as the permit schedule. Extraction is a draft. The permit schedule is the draft after you have cleared the flags.

Confirm the jurisdiction on the jurisdictions page so the code sheet and the schedule are aimed at the same edition. Then upload the plan and the schedule and run a free scan. The scan will not read the cut sheet. You already have to.

This is advisory. It is not a determination by the authority having jurisdiction. Confirm the adopted edition and local amendments before you change a drawing.