Home › Blog › How to read a local building code amendment
AHJ & Permitting

How to read a local building code amendment

The sentence in the city PDF wins over the model book.

InstaPreView · Published November 12, 2026 · Updated November 12, 2026
Line drawing of a city map grid with a location pin beside a stack of code documents, titled “How to read a local building code amendment”. InstaPreView by Byts & Bytes.

A local amendment is not a tip. It is the code, for the section it names, in the place that adopted it. The model International Building Code applies only where the city did not change it. Reading the model book and skipping the ten-page ordinance is how a corridor, a sprinkler threshold, or a submittal rule comes back wrong.

Get the adopting ordinance, not a slide someone made from it. The ordinance will name the model edition — 2018, 2021, or another — and then a list of edits. Typical edits do one of three things: they delete a model section, they replace a model section with city text, or they add a section the model code does not have. The replacement text is the rule. The deleted text is gone, even if every guide you own still prints it. The model 2021 book, for comparison, is at ICC. The ordinance is on the city site. The jurisdictions index is where you start looking for which edition is on file. It does not reprint every amendment.

Read an amendment next to the model section, not instead of a memory.

  • If the ordinance says "Section 1020.5 is amended to read as follows," the dead-end lengths in the dead-end guide may not be the local lengths. Use the ordinance's sentence.
  • If the ordinance amends Table 1020.2, the sprinkler trade in the rated corridor guide may have been removed. Cities do that.
  • If the ordinance adds a submittal rule in the administrative chapter, it sits on top of Section 107. More sheets, not fewer.

A policy memo, a checklist, and a counter handout are not the ordinance. They tell you what the reviewers are looking for. They can be wrong, and they can be newer than the code. When a handout and the ordinance disagree, ask which one the reviewer will enforce, and write that answer on the code sheet. Do not guess.

The mistake is treating "we always do it this way" as an amendment. If you cannot point at a section the city changed, you are describing a habit. Habits do not survive a different reviewer.

Before you issue the set, upload it and run a free scan for the jurisdiction you named. Then read the ordinance for anything the model code still has that the city deleted.

This is advisory. It is not a determination by the authority having jurisdiction. Confirm the adopted edition and local amendments before you change a drawing.