Home › Blog › How to use the occupant load calculator
Industry & Practice

How to use the occupant load calculator

The total is only as good as the rows you refused to lump together.

InstaPreView · Published November 12, 2026 · Updated November 12, 2026
Line drawing of an office floor plan laid out with workstations and a dashed area boundary, titled “How to use the occupant load calculator”. InstaPreView by Byts & Bytes.

The occupant load calculator is a schedule, not a single box. It implements IBC Table 1004.5: area divided by the factor for the function of the space, rounded up, then added across the rooms. The page is at /calculators/occupant-load. The method is the occupant load guide and the factor guide. The model table lives in 2021 IBC Chapter 10, unless the city adopted something else. Check the jurisdictions page and the ordinance before you trust a default edition.

Use it in this order.

Select the code edition in the calculator before you add rooms. A factor from the wrong edition is a wrong load. If the city is not on an edition the tool lists, do the math from the adopted table and do not pretend the tool's edition is close enough.

Add one row per function, not one row per suite. An open office and a conference room full of chairs do not share a factor. The factor guide prints business areas at 150 gross square feet per occupant. Do not put the conference room on that row without reading the assembly row. The function follows the furniture, not the occupancy letter. That distinction is already explained in the guide. The calculator will not correct a row you mislabeled.

Use net or gross the way the factor's row says. Mixing them is the error the guide warns about. Round each room up as the tool does, then read the total. That total is the number you copy onto the code sheet and the life-safety plan. If those two sheets show a different number, you are not done. The coordination comment is what happens next.

From the total, open the egress width calculator. It can take the occupant load from this tool. Width is a second calculation. The load is not a door size.

Export the schedule and put it in the set, or redraw it on the code sheet with the same rows. A total with no backup is a comment that says "show your work."

The mistake is one row called "suite," the whole area, the business factor. You will undercount every room that is denser than an office, and the exits will be designed for the undercount.

Upload the plan that matches the schedule and run a free scan. The calculator does not see the drawing. You have to make them the same document.

This is advisory. It is not a determination by the authority having jurisdiction. Confirm the adopted edition and Table 1004.5 before you change a drawing.